[Hi-zreceivingarraydiscussions] Hi-Z 8 160m

[Lee STRAHAN]

Hello Dave,
   The only time we have ever seen the electronics generate any birdies is when an element has been shorted to ground or installed backwards making the antenna input connected to the ground rod. Check for the 4 to 5 VDC on each element if any are low you may have a bad amp or element leakage problem.
 I have had grass grow up and touch an element connection causing loss of signal and directivity.
   Here is something you try. If you have a voltage adjustment on the array vary the voltage a little to see if the birdies move. If no adjustment then watch carefully as you turn the array power off to see if the birdies move in frequency. If indeed they were being generated in the array I would expect them to change a bit with power.
   All that being said it may be time to pull all the breakers in your house to see if its coming from somewhere else.

 I just got your second message and your comments about the  array are also what will happen if an element is touching some foliage or being shorted out. Directivity and low noise reception suffers.
  There ya go, my best guess.
GOOD LUCK

Lee K7TJR
Hi-Z Antennas



   

>>>
Hello Lee and company. . .

Over the past couple of weeks or so I’ve noticed some spurious signals in my Hi-Z 8 circle 160m array.  I’ve always had BC spurs on 1820, 1830, 1840, etc. but these are low level signals, just a few db above the noise floor.  They seem to be random in frequency spacing.  Some are 1 KHz apart, some more, some less.  They are not clear, stable signals. . .rather, they are warbly and “fuzzy” (something like AU) and seem a little broad.  There are lots of them as I tune up down 20 or 30 KHz in the 1810 – 1835 KHz part of the band.  The array seems to have normal performance, reasonably good directivity, F/B, etc.  The signal levels do not change with direction of the array which leads me to believe it is something internal to the array.  The weather here is very cold right now.  When it decides to warm up I will go out and re-seat all the various connections including the F connectors, connections from the preamps to the elements, element connections to ground rod, etc.  I do have the 75 to 50 ohm box in line as I feed the array from the shack with RG58.  I do not have a preamp in line.  Any ideas what might be going on?  

73. . . Dave, W0FLS
_______________________________________________
Hi-zreceivingarraydiscussions mailing list Hi-zreceivingarraydiscussions at hizantennas.com
http://mail.hizantennas.com/mailman/listinfo/hi-zreceivingarraydiscussions_hizantennas.com