[Hi-zreceivingarraydiscussions] Topband: PE coated RG6
Roger D Johnson
n1rj at roadrunner.com
Fri Dec 14 17:13:59 EST 2012
Did you fold the braid back over the jacket?
Roger
Grant Saviers wrote:
> Just completed cables for an active receive 4 square with Commscope PE
> jacketed flooded RG6 (660-BEF), 1000' on ebay for $35. I used the
> "weathertight" compression fittings and a Radio Shack stepped prep
> cutter. RS has the tools cheap. Extra care is needed to remove the
> braid shards since the flooding goop causes them to stick to
> everything. It is also a challenge to push the cable far enough into
> the connector, next time I'll try the heat gun idea. I found trimming
> the braid away with a flush cutting wire snipper was helpful, but still
> have pretty sore hands.
>
> Grant KZ1W
--
Remember the Liberty (AGTR-5)
http://www.usslibertyveterans.org/
http://www.gtr5.com/
More information about the Hi-zreceivingarraydiscussions
mailing list